Flooring / STAGES
Self-leveling epoxy floor — SL 10
Seamless self-leveling epoxy floor route using Epo Floor S.L 10
Floor Hardeners
MC-Epo Floor S.L 10
Self-Leveling epoxy floor
MC-Epo Floor -SL 10 is a multi- components epoxy system 1mm thickness formulated with self- leveling properties.
| Colour | Available in a wide range of colours |
|---|---|
| Pot life @ 25-30°C | 30 minutes |
| Tack-free time @ 25-30°C | About 12 hours |
| Complete cure @ 25-30°C | 7 days |
| Solvent content | None |
| Density @ 25°C | 1.60 g/cm³ |
| Compressive strength - 7 days | 600 kg/cm² |
| Flexural strength - 7 days | 250 kg/cm² |
| Bond strength - 7 days | > 15 kg/cm² |
| Packaging | 29 kg: 10 kg resin + 4 kg hardener + 15 kg filler |
Description
MC-Epo Floor S.L 10 is a multi-component epoxy flooring system with a nominal 1 mm thickness, formulated with self-leveling properties.
Where to use
Hospitals, slaughterhouses and warehouses. Laboratories and power plants. Textile mills, TV studios, workshops and aircraft hangars. Exhibition halls, bakeries and dairies. Chemical and pharmaceutical plants.
Advantages
Self-leveling properties provide a smooth, uniform surface. According to the source, it does not support normal growth of bacteria, fungi or algae, making it suitable where a high level of hygiene is required. High resistance to mineral oils, fuels, most diluted inorganic acids, alkalis, solutions and organic acids. Produces an extremely smooth, glossy finish. Available in a wide range of colours. High bond strength combined with good abrasion and chemical resistance.
Application rate
MC-Epo Prime primer 200-300 g/m² MC-Epo Floor S.L 10 1.60 kg/m² per 1 mm thickness
Application procedure
Surface preparation: concrete must be clean, dry and free from oil, grease and foreign matter. Repair honeycombs and defective areas before application. Priming: mix the components of MC-Epo Prime thoroughly and apply by roller, brush or spray. Allow sufficient time for the primer to become tacky before applying the flooring mortar. Mixing: mix the components of MC-Epo Floor S.L 10 with a low-speed mixer for 3-5 minutes until a homogeneous, lump-free mixture is obtained. Application: pour the mixed material onto the primed surface, spread uniformly with a notched trowel, then pass a spiked roller repeatedly to release entrapped air bubbles.
Use note
Apply at the thickness and consumption stated in the technical source, taking site conditions and pot life into account.
MCT / SYSTEMS
Where it fits
PROJECT / NEXT STEP
Bring us the condition on site.
Share the project stage, substrate, problem and site condition. If you used Solution Finder, your technical summary comes with you.